The catch
PECRON E1500LFP V3
Make sure you get the current 1000W XT60-input version, since older E1500LFP units have a different solar connector and voltage window.
Side by side
If your overnight energy use is too much for a 1kWh station, or you need its higher-current 12V connection, the E1500LFP V3 is the answer. If a lighter 1024Wh unit covers the trip and you’d rather expand later, pick the Mega 1. The PECRON brings 50% more base capacity, and 10.6 lb more weight with it.
Before you buy
Under an 80% usable-energy allowance, about 329Wh is left on PECRON after the job, whereas Mega 1 comes up about 81Wh short.
Where this comes from
1536 × 0.8 − 900 = 328.8Wh. 1024 × 0.8 − 900 = −80.8Wh. It works as a planning screen and gives no guarantee for a particular fridge.
The catch
Make sure you get the current 1000W XT60-input version, since older E1500LFP units have a different solar connector and voltage window.
The catch
You only get the 36-minute full-charge claim when AC and solar are used together.


We may earn a commission from qualifying Amazon purchases. How we make money
The updated PECRON E1500LFP V3 set against OUPES Mega 1 on overnight energy needs, 12V output, solar input and carrying weight.
Mega 1 makes the initial carry easier, and PECRON’s larger battery helps with overnight energy.
Which one fits
Assuming 80% usable energy, PECRON gets about 1229Wh and Mega 1 about 819Wh.
Mega 1 is 10.6 lb lighter.
A 10A socket lacks the current headroom that the V3 30A connection has.
Each has a defined matching expansion system.
In practice
Under an 80% usable-energy allowance, about 329Wh is left on PECRON after the job, whereas Mega 1 comes up about 81Wh short.
1536 × 0.8 − 900 = 328.8Wh. 1024 × 0.8 − 900 = −80.8Wh. It works as a planning screen and gives no guarantee for a particular fridge.
PECRON weighs about 38.1% more and adds 50% nominal energy and 10% continuous AC output.
Weight: (38.4 − 27.8) ÷ 27.8 × 100 = 38.1%. Also 1536 ÷ 1024 = 1.5 and 2200 ÷ 2000 = 1.1.
A 15A load at 12V comes to 180W. That is over a 12V 10A, 120W socket yet under the V3 30A output rating.
12 × 15 = 180W, against 12 × 10 = 120W and 12 × 30 = 360W. Suitable cables, fusing and connectors are still essential.

PECRON, E1500LFP V3
A sensible in-between choice if 1kWh feels tight but a 2kWh station would weigh more than you’d like. The current V3 brings a simple XT60 solar connection and a useful 30A DC output.

OUPES, Mega 1
A starter battery that’s easy to handle and can grow. The 2000W inverter can cover a short high-draw job. Two optional B2 batteries solve a different problem, keeping smaller loads running longer.
Spec by spec
| Spec | PECRON E1500LFP V3 | OUPES Mega 1 | In practice |
|---|---|---|---|
| Battery capacity | 1536Wh | 1024Wh | Nominal energy is 50% higher on PECRON. |
| Continuous AC output | 2200W | 2000W | The capacity gap is much larger than the inverter gap. |
| Listed weight | 38.4 lb | 27.8 lb | Mega 1 is 10.6 lb lighter. |
| Maximum solar input | 1000W on V3 | 800W | Compared with the older E1500LFP specification, the V3 solar input is higher. |
| Higher-current 12V output | 12V 30A on V3 | 12V 10A car output | With correct wiring, the PECRON connection suits larger compatible DC loads. |
| Maximum expansion capacity | 9216Wh with two EP3800 batteries | 5120Wh with two B2 batteries | Both expand, but each brand has its own batteries and cables. |
Trade-offs
Decision guide
Before picking a battery size, measure the watt-hours you need between chances to recharge.
Because a refrigerator cycles, its compressor wattage doesn’t tell you its total overnight energy use. Measure watt-hours across the hours you need to cover, then add a reserve allowance. The E1500LFP V3 starts with 512Wh more than the Mega 1, which helps when your measured requirement already stretches the limits of a 1kWh station.
Over time, PECRON has revised the E1500LFP hardware. This comparison is about the V3, with 1000W solar input and the higher-current 12V connection. Older material may still show 700W solar and a different connector arrangement. Before buying accessories built around the V3 features, confirm the specification on the current Amazon listing and the model that is delivered.
Compared with the usual 12V 10A car socket, the V3 12V 30A output has more current headroom. That can suit a larger compatible DC setup, but the load, cable, fuse, connector and polarity must all match. Having a 30A output doesn’t mean you can run high-current equipment through a cable designed for a cigarette-lighter socket.
By the numbers
What we found across the portable power stations we compare, plus the checked facts behind each finding.
Only 5 of the 50 models checked meet every need here: “I need an efficient way to power a 12V fridge”, “I might expand battery capacity later”, and “I need power at campsites and on weekends away”.
5 models fit, out of 50 checkedPECRON E1500LFP V3 lists 1,536 Wh for battery capacity, 50% more than the 1,024 Wh on OUPES Mega 1.
How we countedThe count uses each product's current fit ratings for “I need an efficient way to power a 12V fridge”, “I might expand battery capacity later”, and “I need power at campsites and on weekends away”. A need with no documented match is not counted.
How we calculatedThese are nominal watt-hour ratings. How much energy you get out depends on inverter losses, temperature and load. For context, 50 of 50 models publish comparable figures.
| Product | Needs it meets | Facts we checked | Sources |
|---|---|---|---|
| PECRON E1500LFP V3 |
|
|
|
| OUPES Mega 1 |
|
|
|
Ready to buy
Open either model on Amazon for the current price, customer reviews and delivery options.

A 1024Wh battery can’t provide the reserve your measured overnight demand requires.
See price & reviews on Amazon
Your trip fits within the smaller energy budget, and you want a lighter station.
See price & reviews on AmazonEach link opens in a new tab.
We may earn a commission from qualifying Amazon purchases. How we make money