The catch
Anker SOLIX C1000
Compared with the C1000 Gen 2 it weighs more and has a lower continuous AC rating. The two generations also don’t share the same expansion path.
Side by side
Two solar inputs and a faster transfer limit point to the DELTA 3 Plus. The original C1000 holds slightly more energy and weighs about the same.
Before you buy
A steady 300W load models out to about 2.8 hours on Anker SOLIX C1000 and 2.7 hours on EcoFlow DELTA 3 Plus.
Where this comes from
Hours = nominal Wh × 0.8 / 300W, using inputs of 1056Wh and 1024Wh. The 80% factor allows for unusable energy and conversion losses and is shared for planning. It is not a measured efficiency. Idle draw, temperature and the real load will change runtime.
The catch
Compared with the C1000 Gen 2 it weighs more and has a lower continuous AC rating. The two generations also don’t share the same expansion path.
The catch
Despite a similar 1kWh battery, its 1,800W continuous inverter is lower than the C1000 Gen 2’s. X-Boost leaves that normal output limit unchanged.


We may earn a commission from qualifying Amazon purchases. How we make money
The DELTA 3 Plus is the choice for two solar inputs and a faster transfer limit. At a similar weight, the original C1000 stores slightly more energy.
The added capacity is too little to decide it
Which one fits
The C1000 holds 1,056Wh, versus 1,024Wh. In the 300W planning example that works out to about five extra minutes, which makes input layout the more useful deciding factor.
The DELTA 3 Plus gets to 1,000W by way of two 500W inputs, so a single large panel connection doesn’t automatically unlock the combined rating. The C1000 lists 600W total.
In the shared planning case, Anker SOLIX C1000 reaches 2.8 hours and EcoFlow DELTA 3 Plus 2.7. Before picking a required overnight reserve, measure the actual wattage.
Maximum input is 600W on Anker SOLIX C1000 and 1000W on EcoFlow DELTA 3 Plus. Compare your real panel strings against the voltage and current limits as well as this total.
In practice
A steady 300W load models out to about 2.8 hours on Anker SOLIX C1000 and 2.7 hours on EcoFlow DELTA 3 Plus.
Hours = nominal Wh × 0.8 / 300W, using inputs of 1056Wh and 1024Wh. The 80% factor allows for unusable energy and conversion losses and is shared for planning. It is not a measured efficiency. Idle draw, temperature and the real load will change runtime.
Anker SOLIX C1000 stores about 37.1 nominal watt-hours per pound and EcoFlow DELTA 3 Plus stores 37.1.
Nominal energy over published weight gives 1056 / 28.44 and 1024 / 27.6. It is a comparison of stored energy per lifting weight and not of measured efficiency or handle comfort.
Over C1000, DELTA 3 Plus gives about 67% more maximum solar intake, but C1000 keeps about 3% more nominal battery capacity.
(1000 / 600 - 1) × 100 = 66.7% and (1056 / 1024 - 1) × 100 = 3.1%. The DELTA solar total needs both inputs.

Anker SOLIX, A1761
The original C1000 combines 1,056Wh with an 1,800W inverter and can take a matching expansion battery. It still makes sense when adding capacity is a higher priority than saving weight.

EcoFlow, DELTA 3 Plus
This 1,024Wh station cares more about quick solar recovery and high-power USB-C than about headline battery size. Its two 500W solar inputs can each take a separate panel string.
Spec by spec
| Spec | Anker SOLIX C1000 | EcoFlow DELTA 3 Plus | In practice |
|---|---|---|---|
| Nominal battery energy | 1056 Wh | 1024 Wh | The starting runtime budget comes from stored energy. |
| Continuous AC output | 1800 W | 1800 W | Load screening uses this sustained rating, which is separate from surge and boost modes. |
| Lifting weight | 28.44 lb | 27.6 lb | Flat ground is where wheels help. A trunk, step or shelf still takes a lift. |
| Maximum solar input | 600 W | 1000 W | Panel voltage, current and per-port limits have to fit as well. |
| Dedicated battery expansion | Supported with compatible equipment | Supported with compatible equipment | Integrated battery expansion is not the same as charging from an external source. |
| Published transfer limit | 20 ms | 10 ms | Check the exact device being connected. Even a short transfer specification can’t guarantee that every load runs without interruption. |
Trade-offs
Decision guide
Pick the DELTA 3 Plus if you want two solar inputs and a quicker transfer limit. The original C1000 offers slightly more stored energy at a similar weight.
The C1000 holds 1,056Wh, versus 1,024Wh. In the 300W planning example that works out to about five extra minutes, which makes input layout the more useful deciding factor.
The DELTA 3 Plus gets to 1,000W by way of two 500W inputs, so a single large panel connection doesn’t automatically unlock the combined rating. The C1000 lists 600W total.
Compatible expansion batteries work with either one. Weigh the whole future battery and cable plan, since matching watt-hours don’t make accessories interchangeable.
By the numbers
What we found across the portable power stations we compare, plus the checked facts behind each finding.
Only 6 of the 50 models checked meet every need here: “I need power at campsites and on weekends away”, “I want backup power for the essentials at home”, and “Solar will be a real part of how I recharge”.
6 models fit, out of 50 checkedHow we countedThe count uses each product's current fit ratings for “I need power at campsites and on weekends away”, “I want backup power for the essentials at home”, and “Solar will be a real part of how I recharge”. A need with no documented match is not counted.
| Product | Needs it meets | Facts we checked | Sources |
|---|---|---|---|
| Anker SOLIX C1000 |
|
|
|
| EcoFlow DELTA 3 Plus |
|
|
|
Ready to buy
Open either model on Amazon for the current price, customer reviews and delivery options.

Get a base battery with slightly more energy
See price & reviews on Amazon
Set up solar with two inputs
See price & reviews on AmazonEach link opens in a new tab.
We may earn a commission from qualifying Amazon purchases. How we make money